5 bare rods
Equip several kits or keep spares for practice.
3/8 × 4 inches
Approximately 9.5 mm diameter × 101.6 mm length.
15,000 strikes
Per rod. Actual wear varies with technique and pressure.
See a ferro rod in action
Watch a shared FERROFIRE rod-and-striker demonstration.
The model, rod size and accessories shown may differ. This product is a bare-rod pack; the striker and other accessories shown are not included.
Bare rods. Your setup.
The FERROFIRE Classic 5-Pack gives you five undrilled ferrocerium rods for custom fire starters, camping kits and bushcraft practice. The plain rod design lets you choose your own handle and carry setup.
These rods have no lanyard hole. Choose this version when you want a blank for a DIY project rather than a ready-to-use lanyard attachment. The 4-inch length provides room to hold and strike the rod, while the 3/8-inch diameter offers a practical everyday size.
Package contents: Five bare ferrocerium rods. No striker, handle or lanyard is included. Accessories shown in instructional images are sold separately.
At a glance
- Quantity: 5 rods
- Material: Ferrocerium
- Diameter: 3/8 inch (approximately 9.5 mm)
- Length: 4 inches (101.6 mm)
- Lanyard hole: None
- Strike capacity: 15,000 strikes per rod
- Striker: Not included
Prepare, strike and practice
Five clear steps, plus a separate striker guide, each with its own photo. These shared technique photos show a different FERROFIRE setup. The striker, cord and assembled fire starter shown are not included in this pack of bare rods.
Step 1
Prepare your tinder
Gather dry, finely prepared tinder and kindling. Place the tinder on a suitable fire-safe surface.
Step 2
Expose the ferrocerium
Scrape a small area of the black protective coating away to reveal the silver ferrocerium underneath.
Step 3
Position the striker
Place the scraping edge against the exposed rod, close to your prepared tinder. Keep fingers and any cord clear of the striking path.
Step 4
Brace your hand
Hold the striker securely and keep that hand steady near the tinder. Check your grip before making a stroke.
Step 5
Pull the rod back
Draw the rod toward you against the steady striker to direct sparks into the tinder. Adjust the angle and pressure with practice.
Striker guide
Choose a scraping edge
Use a suitable ferro-rod striker. On the SA02 shown here, use a straight scraping edge for the rod; the serrated end helps prepare wood shavings.
Practice safely. Tinder preparation and technique matter. Sparks alone do not guarantee ignition, especially with damp tinder. Use only where fires are permitted, keep clear of other flammable items and fully extinguish your fire before leaving.
Choose the right Classic rod
Does this version have a lanyard hole?
No. This is the undrilled version. If you want to attach a cord directly through the rod, see the Classic 5-Pack with lanyard holes.
Is it a complete fire-starting kit?
No. You receive five bare rods. Add a suitable striker and your preferred handle or storage setup separately.
Why is the rod coated black?
The coating helps protect the ferrocerium before use. Remove it only from the area you intend to strike, and wipe the rod dry before storage.
How many strikes can I expect?
The Classic 3/8-inch rod is rated for 15,000 strikes per rod. The amount of material removed depends on your striker, pressure and technique.
A closer look at the striking technique
Prepare suitable dry tinder and practice controlled strokes before relying on a ferro rod outdoors.
Shared FERROFIRE demonstration, not a presentation of this pack’s contents. The rod and accessories shown may differ. Use only where fires are permitted and fully extinguish any fire before leaving.










Scary –
great ferro rods, and produce a lot of spark for very little strike. I keep one of these with a striker in the kitchen so I can still start our gas stove if the power goes out. If you need good kindling, I would recommend soaking some cotton balls in Vaseline, puffing them up a bit, and using this to light them. Half of one cotton ball will burn for a couple minutes, they’re water resistant, and you can use a bit of the Vaseline to keep your ferro rod from rusting.
R. M. Greene –
I threw a small piece of cord through the hole and called it a day. Does the job as expected. I used with a knife, and did not purchase the accompanying striker.
Maggie –
These fit into the cavity in compression fire starters.
Scott –
They worked great, have them in my SHTF bug out bag.