9/16-inch diameter
Approximately 14.3 mm across.
4-inch length
101.6 mm from end to end.
20,000 strikes
Per rod. Actual wear varies with technique and pressure.
See a ferro rod in action
Watch a shared FERROFIRE rod-and-striker demonstration.
The model, rod size and accessories shown may differ. This is a bare-rod listing; the striker and other accessories shown are not included.
Choose your cord and striking technique
The FERROFIRE Super-Duty is a drilled ferrocerium rod measuring 9/16 inch in diameter and 4 inches long. It is intended for camping, bushcraft practice and custom fire-starting setups.
The lanyard hole gives you a place to thread a suitable cord when arranging your kit. Check that the cord fits and that your setup leaves room to grip the rod and work with a suitable ferro-rod striker.
The rod is rated for 20,000 strikes. This is a stated wear capacity, not a guarantee of that many successful fires: tinder preparation, weather, striker choice and technique all affect the result.
At a glance
- Material: Ferrocerium
- Diameter: 9/16 inch (approximately 14.3 mm)
- Length: 4 inches (101.6 mm)
- Lanyard hole: Drilled
- Strike capacity: 20,000 strikes per rod
Work close to well-prepared tinder
Five clear steps, plus a separate striker guide, each with its own photo. These shared technique photos show a different FERROFIRE setup. They illustrate the technique, not the package contents for this listing.
Before striking, choose a suitable ferro-rod striker and prepare dry tinder and kindling. Keep loose cord clear of the scraping edge and the area where sparks will land.
Step 1
Prepare your tinder
Gather dry, finely prepared tinder and kindling. Place the tinder on a suitable fire-safe surface.
Step 2
Expose the ferrocerium
If a protective coating covers the rod, scrape a small area away to reveal the silver ferrocerium underneath.
Step 3
Position the striker
Place the scraping edge against the exposed rod, close to your prepared tinder. Keep fingers and any cord clear of the striking path.
Step 4
Brace your hand
Hold the striker securely and keep that hand steady near the tinder. Check your grip before making a stroke.
Step 5
Pull the rod back
Draw the rod toward you against the steady striker to direct sparks into the tinder. Adjust the angle and pressure with practice.
Striker guide
Choose a scraping edge
Use a suitable ferro-rod striker. On the SA02 shown here, use a straight scraping edge for the rod; the serrated end helps prepare wood shavings.
Practice safely. Tinder preparation and technique matter. Sparks alone do not guarantee ignition, especially with damp tinder. Use only where fires are permitted, keep clear of other flammable items and fully extinguish your fire before leaving.
Before you choose
What are the rod dimensions?
The listed size is 9/16 inch in diameter by 4 inches long, equivalent to approximately 14.3 mm by 101.6 mm.
Can I add a cord through the rod?
Yes. This is the drilled version with a lanyard hole. Check the hole against your chosen cord before planning a custom carry setup.
Does 20,000 strikes mean 20,000 fires?
No. The rating describes strikes, not successful ignitions. How much material each strike removes and whether the sparks ignite tinder depend on your equipment, preparation and technique.
Can sparks replace dry tinder?
No. Prepare dry, fine tinder and suitable kindling. Wet conditions can make ignition harder, so practice beforehand and protect your tinder from moisture.
A closer look at the striking technique
Prepare suitable dry tinder and practice controlled strokes before relying on a ferro rod outdoors.
Shared FERROFIRE demonstration, not a presentation of this product’s included contents. The rod and accessories shown may differ. Use only where fires are permitted and fully extinguish any fire before leaving.











Reviews
There are no reviews yet